Do you dream of an exquisite floor? Are you inspired by beauty and
seek exceptional quality with practical appeal? Then Dura Wood flooring
is the answer to your dreams.
Natural wood under your feet feels warm and homely. Hardwood
or bamboo flooring in your home reflects a personal image and
is a major design feature. There is a wide range of styles available
to reflect your individuality so, you can have a floor that compliments
the interior design chic of tomorrow and bring a comfortable atmothsphere
into your home.
Dura Wood flooring will add warmth to your home and because it
has a natural grain, each floor is unique, allowing your home
to stand out from the rest.
Dura Wood flooring is hardwearing and durable and very easy to
maintain, any spills are easily wiped up and you would never even
know they happened.
Laying your hardwood or bamboo flooring could not be easier!
You will need the following tools:- Tape measure, pencil, saw.
Below is a step by step guide to laying Dura Wood flooring.
Choose the species and shade of Dura Wood flooring you would
like and then select the board widths you prefer depending on
the look you are going for. Remember, narrow planks will make
your space look longer.
Measure the width and length of the room and multiply the two
measurements together to find the square footage. Dont forget
to add 10-15 percent extra to your order to allow for irregular
boards and any cutting mistakes that are made.
Check the sub-floor to make sure you have a good surface to lay
your dura wood flooing. Its recomended you have a minimum 3/4"
plywood sub-floor. Make sure the sub floor has no squeaks and
if there are, simply screw a long drywall screw into the sub-floor
and joist where the squeak occurs. Remove any shoe-molding,or
if you want a cleaner finish remove the baseboard from the room
and sweep and clean thoroughly.
To keep your finished dura wood floor in top condition for years
after installation be sure to use a vapor barrier. BuildDirect
have 100ft rolls of moisture block for around $0.19 sq/ft. Mark
with a pencil along the baseboards where the joists are located.
Start the installation at the longest wall that has the least
obstructions (doors etc) and at right angles to the direction
in which the joists run. If you only removed the shoe-mouldings
then mark a chalk line 3/8" out from the baseboard (this will
allow your dura wood flooring to expand and contract as the temperature
changes from season to season).
Begin the first row with a long board. Get the edge of the board
snug to the chalk line and drill pilot holes down through the
dura wood plank and into the sub-floor and joist. using a nail
gun will vastly speed up this process but if you dont own one
take care not to hit your thumb too many times!! It is important
to lay the first boards perpendicular to the joists which are
underneath to give you a nice solid anchor.
After the first few rows have been installed, drill pilot holes down into
the tongue of each board and hand-nail the rolls until there is
enough clearance for the nail gun if you are using one.Its a good
idea to lay out a box of hardwood boards ahead of actally fixing
them in oplace. This will allow you to pre select the lengths,
colors and wood grain of the boards to make surfe your Dura Wood
floor looks its best. Its best to never allow the ends of adjoining
boards to align, keep around 6in distance between them, this will
help strengthen your floor as well as be more aesthetically pleasing.
When installing up to a doorway, it is not critical to make
cuts exact. Come back later after the floor has been installed
and use a circular saw or multi tool to cut across the threshold
to make the finish precise.
When you reach the end of a row, select a piece that is around
10-12 inches longer than the gap between the last board and the
basebpard. Use the off cut piece on the beginning of the next
row. This will save both time and waste and give your floor a
There will inevitably be the need to rip (make a length wise
cut) the last row of boards. Dont forget your expansion gap of
around 3/8" when making your measurements and cuts.
Once you have the floor fixed in please, replace the shoe molding
in the room and apply putty to all of the nail holes that you
have face-nailed. You can get putty to match the species or shade
of the floor so it doesnt look too out of place. Wipe any excess
putty away as you go to prevent the need for sanding.
Then you are done and you can sit back and enjoy your Dura Wood
flooring. maintencance is easy, sweep on a regular basis to remove
any grit so it doesnt scratch. You can use a microfibre broom
to pick up dust and give the floor a buff. There is no need to
use chemicals just lightly dampen the microfibres and they will
do the rest.
A stunning floor deserves a stunning finish, so choose your trims
that guarantee a seamless transition from floor to wall.
When your hardwood or bamboo flooring stops and the flooring
of another room start there are door bars that can be used to
gracefully take you through into the next room.
And for the perfectionist there are pipe covers that hide the
expansion cap around your pipes.
All in all Dura Wood flooring is amongst the most hardwearing
durable and hassle free type of flooring available. And with so
many styles to choose from there is something for everyone.
Hardwood Floor Care Will Keep Your Hardwood Looking Fantastic
Hardwood is still the homeowner’s favorite choice of flooring
and caring for it takes minimal effort.
Unlike laminate or engineered wood, hardwood can be refinished
many times, and will add years of beauty and warmth to your home,
as well as increase its value and speed its resale.
Ongoing floor care is needed to keep your hardwood looking its
best, however, and there are four major aspects of hardwood floor
1. Hardwood floor cleaning
2. Hardwood floor repair
3. Hardwood floor refinishing
4. Hardwood floor protection
Clean Your Hardwood Regularly Knowing how to clean hardwood floors
is important because the bane of hardwood is dirt and grit, which
will scratch and mark the floor if not removed promptly.
As well, dust is seen more easily on wood floors than it is
on linoleum or on carpet, especially in the sunlight and especially
if the floor has a dark stain.
Hardwood floor care, therefore, means sweeping and dusting regularly
– once a week, at least, and after any event that leaves dirt
and grit behind. Regular household dusting and cleaning products
will cause damage, however, and you must use only products specifically
designed for hardwood.
Vacuuming is preferable to sweeping because it allows the dirt
and dust to be pulled from between the boards, but use a vacuum
with a bare floor attachment, not a beater bar, which can damage
When a more in-depth cleaning is required, use a cleaning method
appropriate to the finish on your floor.
If your floor has a glossy finish, it means that polyurethane,
or a water-based urethane, or a similar finish has been used to
form a protective barrier over the hardwood.
If it has a matte finish, it means that the floor is protected
with a penetrating seal of oil and/or wax.
On neither of these finishes is water an acceptable cleaning
agent, but both of them can accept a surface, damp-mop cleaning,
which means the mop is not wet but only damp to the touch. You
are cleaning only the surface and not using enough water to penetrate
even the oiled-and-waxed hardwood. When using a damp mop on oil
and waxed hardwood, you can add a little neutral ph hardwood floor
cleaner to the water before dipping the mop into it.
A floor with a protective glossy barrier can accept a generic
hardwood floor cleaner providing it doesn’t contain any wax or
The don’ts are every bit as important as the do’s in hardwood
1. Don’t use ammonia, regular floor cleaners, household cleaners,
or dusting products on hardwood.
2. Never use wax on a floor with a urethane or other glossy
3. Never wash hardwood; use only a slightly damp mop.
Repair Any Damage to Your Floors as Soon as Possible In most
cases, when your oil and waxed hardwood floors have suffered surface
damage, you have to remove the finish with a wax or oil stripper
before dealing with the damage.
After completing the repair, you then re-wax or re-oil the area.
Surface damage occurs less often on hardwood protected by polyurethane
or a similar type of sealer, and when it does, the damage is not
When repairing floors with such finishes, strip the finish from
the entire board or boards where the damage has occurred. Make
your repairs and then apply a finishing product to those boards
that is consistent with the rest of the floor.
1. Water marks: Remove the protective finish, rub the marks
with fine grade steel wool. Repeat if necessary, clean, and then
2. Burn marks: Lightly sand the area, use a damp cloth to pick
up the grit, and then refinish as desired.
3. Scratches and gouges: Conceal shallow scratches with matching
wood putty or a putty stick. After the area is dry, sand and refinish.
Refinishing Your Worn Hardwood Floors Will Recapture Their Original
Beauty and Value
In a home with shabby hardwood floors, the biggest improvement
you can make is to refinish the floors. Begin by making any necessary
repairs, and then removing all the furniture and drapes and sealing
the vents and registers in the room so that you won’t spread dust
throughout the house.
Sanding floors is easiest to do with a drum sander and an edging
machine for the sides and corners of the room. You can rent these
machines, and it is a good idea to rent a buffer or floor polisher
at the same time. Plan to make three passes with your sanding
equipment, using increasingly finer sandpaper each time. Vacuum
carefully and pick up every bit of fine dust and grit with tacking
cloths. All dust and dirt must be removed.
You can now apply a stain if you wish or you can leave the natural
color and design of the wood – such as the popular oak, maple,
or cherry – to be displayed. Polish and clean the dust and dirt
from the floor again, and then apply your sealer – a polyurethane
or a water-based urethane that provides a protective barrier,
or oil and wax, which penetrates the wood and protects from within.
Carefully read all the information accompanying each product,
follow the safety advice, and apply as many coats of stain or
sealer as suggested by the manufacturer of the products you are
Hardwood Floor Care Means Providing Ongoing Floor Protection
As well as regular cleaning, and repairing and refinishing when
necessary, there are a number of protective measures you can take
to preserve the beauty of your hardwood:
1. Use area rugs and mats in high traffic areas and sites of
frequent spills (e.g., in front of the stove, sink, and refrigerator).
Move these rugs frequently so that these areas of the floor remain
the same color as the exposed floor. As well, it is best to choose
cotton mats as they do not trap water under them as rubber or
2. Keep high-heeled shoes in good repair and avoid using stiletto
3. Keep nails trimmed on pets.
4. Clean up spills immediately with a paper towel or dry cloth.
A damp cloth can be used for sticky spills, but dry the spot immediately
afterwards with another towel or cloth.
5. Lift rather than drag furniture when moving it and use felt
contacts under furniture legs to prevent scratches and gouges.
6. Use sheers or blinds to protect your floors from the discoloration
caused by direct sun rays.
With proper care and maintenance, your hardwood floors will
retain their beauty and enhance any décor that you choose. When
your floors become worn, or if they become damaged, they can be
restored to their former glory with a little time, effort, and
Use the Internet to check out quality products, read the information
on how to use them, compare prices, and place your orders. We
can help with all your hardwood floor care needs – everything
from discount hardwood flooring to hardwood cleaners – and all
items can be purchased online and delivered to your door. Let
us help you keep your hardwood floors looking their best.
Scott Gray is currently freelance writing and
enjoys providing information and moneysaving tips to consumers
who are in the market for hardwood floors, hardwood floor care
and hardwood flooring articles. Article Source: http://EzineArticles.com/